At present, the application of the CNC working center is more and more extensive, its processing flexibility is good, the precision is high, the production efficiency is high, it has many advantages. But the CNC technology is more and more advanced, complex, the quality of maintenance personnel requirements is very high, requiring them to have deep professional knowledge and rich experience in maintenance. The correct operation and maintenance of CNC working center is one of the key factors for the correct use of the CNC working center. Correct operation can be used to prevent machine tools, non normal wear and tear, avoid sudden failure, do a good job of daily maintenance, to keep the equipment in good technical condition, slow down the aging process, timely find and eliminate hidden troubles, so as to ensure safe operation. STYLECNC will share the daily maintenance of CNC working center, you need to pay attention to the matter:
1. CNC working center using environment.
In order to ensure the service life of the CNC working center, it is generally required to avoid direct exposure to sunlight and other heat radiation.
2. Good power supply.
In order to avoid the influence of power fluctuations of large (greater than + 10%) and the possible interference signal, CNC working center machine tool commonly used in the special power supply (such as from a low voltage power distribution room a road alone for CNC machine tools) or adding stabilizer etc. can reduce the quality of power supply and electrical interference.
3. The development of effective control procedures.
A series of practical and effective control procedures should be set up in the use and management of CNC working centers. For example, lubrication, maintenance, use and norms of the system, is the main content of the use and management of CNC working center. To develop and follow the operation procedures is one of the important measures to ensure the safe operation of the CNC working center. Practice has proved that many faults can be reduced by compliance with the operating procedures.
4. CNC working center is not suitable for long-term storage
After the purchase of CNC working center to make full use of, especially in the use of the first year, so that the weak link to the failure of the early exposure, to be able to be excluded from the warranty period. In order to reduce the opening and closing of the main shaft of the CNC working center in order to reduce the wear of the clutch, gear and other parts of the device. When there is no processing tasks, wood processing center also need to regularly power, preferably 1 to 2 times a week, each time 1 hours. Using the heat of the machine itself to reduce the humidity of the machine, so that the electronic components are not affected by moisture, but also can be found in a timely manner without the battery power shortage alarm, to prevent the loss of system setting parameters.